28
Note!
The event codes E52-E54 are generated by the
data communication unit (SACO 100M, SRIO
500M, SRIO 1000M, etc.)
Code Event Weight factor Default value
of the factor
E9 Starting of stage I
0
>11
E10 Resetting of starting of stage I
0
>20
E11 Operation of stage I
0
>41
E12 Resetting of operation of stage I
0
>80
E13 Starting of I
0
>> stage 16 1
E14 Resetting of starting of stage I
0
>> 32 0
E15 Operation of stage I
0
>> 64 1
E16 Resetting of operation of stage I
0
>> 128 0
Default checksum for mask V156 85
E17 Output signal TS1 activated 1 0
E18 Output signal TS1 reset 2 0
E19 Output signal SS1 activated 4 0
E20 Output signal SS1 reset 8 0
E21 Output signal SS2 activated 16 0
E22 Output signal SS2 reset 32 0
E23 Output signal SS3 activated 64 0
E24 Output signal SS3 reset 128 0
E25 Output signal TS2 activated 256 1
E26 Output signal TS2 reset 512 1
Default checksum for mask V157 768
E50 Restarting * -
E51 Overflow of event register * -
E52 Temporary interruption in data communication * -
E53 No response from the module over the data
communication * -
E54 The module responds again over the data
communication * -
0 not included in the event reporting
1 included in the event reporting
* no code number
- cannot be programmed
To Next Page
Loading...
