What to do if flowrate is greater than 115% in ABB TRIO-WIRL ST4000?
If the flowrate exceeds 115% on your ABB Measuring Instruments, it may be due to the flow range setting being too small or the flowrate being too large. Try increasing the Qmax flow range or reducing the flowrate to resolve this issue.
What to do if Qv is greater than 115% QmaxDN in ABB TRIO-WIRL ST4000?
If Qv exceeds 115% QmaxDN in your ABB Measuring Instruments, reduce the flowrate.
What to do if the internal data base corrupted in ABB TRIO-WIRL ST4000 Measuring Instruments?
If the internal data base is corrupted in your ABB Measuring Instruments, try turning the instrument off and on. If the problem persists, consider exchanging the converter module.
What to do if the external data base corrupted in ABB TRIO-WIRL ST4000?
If the external data base is corrupted on your ABB Measuring Instruments, try turning the instrument off and on. If that doesn't work, the sensor board may be defective.
What to do if temperature error is displayed when a PT100 is installed in ABB TRIO-WIRL ST4000?
If you're seeing a temperature error when a PT100 is installed in your ABB Measuring Instruments, it could be due to a defective PT100 sensor or a wiring error between the flowmeter primary and converter. Try exchanging the sensor and checking the interconnections.
How to fix steam calculations in ABB TRIO-WIRL ST4000?
To fix steam calculation issues in ABB Measuring Instruments: * If the steam temperature is less than 55°C, increase the steam temperature. * If the steam temperature is greater than 370°C, decrease the steam temperature.
What to do if totalizer is defective in ABB TRIO-WIRL ST4000?
If the totalizer is defective in ABB Measuring Instruments, reprogram the totalizer.
What to do if Kit-FRAM defective in ABB TRIO-WIRL ST4000 Measuring Instruments?
If the Kit FRAM is defective in ABB Measuring Instruments, order a new KIT-FRAM from the factory in Göttingen, Germany.
What to do if preamplifier board defective in ABB TRIO-WIRL ST4000 Measuring Instruments?
If the preamplifier board is defective in ABB Measuring Instruments, exchange converter module.
General| Brand | ABB |
|---|---|
| Model | TRIO-WIRL ST4000 |
| Category | Measuring Instruments |
| Language | English |
Overview of TRIO-WIRL V vortex and TRIO-WIRL S swirlmeters.
Key features of the TRIO-WIRL flowmeters, including no moving parts.
Structure of the instruction manual sections.
Introduction to the Swirlmeter, its capabilities and special features.
Explanation of vortex generation and frequency measurement.
Guide to interpreting Swirlmeter model number configurations.
Procedures for inspecting, locating, and mounting the Swirlmeter.
Method for selecting appropriate Swirlmeter size based on flow conditions.
Technical details and overview of Swirlmeter models.
Introduction to the Vortex Meter, its capabilities and special features.
Explanation of the Karman Vortex Street and detection principle.
Guide to interpreting Vortex Meter model number configurations.
Procedures for inspecting, locating, and mounting the Vortex meter.
Method for selecting Vortex Meter size based on flow conditions.
Technical details and overview of Vortex Meter models.
Introduction to the TRIO-WIRL converter and mounting options.
How to rotate the converter housing and display for optimal visibility.
Procedures for entering data via pushbuttons or magnetic stick.
Basic operation, self-test, and display unit configuration.
Overview of HART, Profibus, and Fieldbus communication protocols.
Technical specifications for the converter module.
Steps for initial meter installation and power-up verification.
Wiring diagrams and guidelines for integral and remote models.
How to set parameters like meter size, flow mode, and calibration factors.
Explanation of the menu levels and available parameters.
Procedures for changing display language and operational modes.
How error messages appear, their codes, and descriptions.
Introduction to available replacement parts for flowmeters and converters.
Detailed list of flowmeter and signal converter components with part numbers.
To Next Page
