9
Display:
To check the daily profile set up without the risk of modification or
deletion:
Select the mode using menu and press enter.
Select the channel (C1 or C2) using + or - and press enter.
The first step of Monday is displayed as well as the daily profile.
Two options available for display:
1. Pressing repeatedly + or -: lets you shift days.
In this case only the first daily step is displayed as well as the daily
profile.
2. Pressing enter: all steps of each day appear one after the other.
Modification or clearing of a program step: prog modif
Select the prog mode with menu and press enter.
DT2-IK: Select the channel (C1 or C2) using + or - and press enter.
Select the modif mode with + or -.
Validate with enter.
The number of remaining program steps appears for a short time.
The first step of the first day or group of days appears.
Repeatedly pressing the enter key displays all programmed steps one at a
time.
Any flashing field (state, hour, minutes) may be modified using + or - ,
then validated with enter.
When the cursor is positioned on ok located behind the group of days, you
may display successively the days or the groups of days and switch directly
to the one that has to be modified using + or -.
To remove a program step:
select the state of the channel (On, Off, On or Off ), press
simultaneously + and -.
Clear.appears on the screen.
Validate with enter.
Key
As soon as the key appears on the switch appear on the screen.
Two types of operation:
To Next Page
Loading...
