ABB VortexMaster FSV430 - Configuration of the Analog-; HART-Input; Configuration of the Parameters Dependent on the Operating Mode; Select the End Value for the Current Output; Setting the Damping Value

SwirlMaster FSS430, FSS450 VortexMaster FSV430, FSV450 | CI/FSS/FSV430/450-EN Rev. D 43
Continued
Ext.Cutoff Trigger
Liquid Mass Corr.
Volume Exp.Coef.
1) 7)
Density Exp.Coef.
1) 7)
Heat Capacity
Gas Density Selec.
Gas Ref. Conditions
3) 5) 6)
Gas Std. Mode
Gas Energy Density
Steam Type
4)
Steam Density Selec.
Ref. Density
1) 3)
Preset Density
1) 3) 4)
Ref. Temperature
1) 3) 6) 7)
Preset Int.Temp
1) 3) 4) 5) 7)
Preset Ext.Temp
Preset Pressure
3) 4) 5) 6)
Preset Gas Content
Qvmax
QnMax
3) 5) 6) 7)
QvpMax
6) 8)
QnpMax
6)
QmMax
3) 4)
QpowerMax
Damping Qv
Damping Qn
1) 3) 5) 6) 7)
Damping Qvp
6) 8)
Damping Qnp
6)
Damping Qm
3) 4)
Damping Qpower
Temp->I=0%
Damping Temperature
Iout at Alarm
Low Alarm Value
High Alarm Value
Auto Zero
Low Flow Cutoff
Device Info
...Sensor Sensor Type
Meter(V) Size
QvMaxDN
QvpMaxDN
6) 8)
QmMaxDN
1) 3) 4)
QnMaxDN
5) 6) 7)
QnpMaxDN
6)
QpowerMaxDN
Sensor ID
SAP/ERP No.
Sensor Run Hours
...Calibration Cal. Date
Cal. Cert. No.
Cal. Location