Instruction Booklet: Troubleshooting
Flash Description Meaning
1
Battery Low
The
batteries are running low.
.
Recharge the batteries for a minimum of 12 hours .
2
Low Battery Fault
The batteries have run out of charge.
.
Recharge the batteries .
Battery voltage is too high. This may occur if
3
High Battery
overcharged &/or traveling down a long slope.
.
If traveling down a slope, reduce your speed to minimize the
Fault
amount of regenerative charging.
.
Check the battery and associated connections and wiring .
The motor has been exceeding its maximum current
4
Current Limit
rating for too long. This may be due to a faulty motor.
.
Check the motor and associated connections and wiring .
Time-Out
.
Turn
the
controller
off, leave for a few minutes and turn back
on
again.
Either a park brake release switch is active or the park
5
Park Brake
brake is faulty.
Fluid
.
Check the park brake and associated connections and wiring.
.
Ensure any associated switches are in their correct positions .
The Throttle is out of neutral when turning the controller
6
Throttle
on.
OONAPU
.
Ensure
the
throttle is in neutral when turning
the
controller on.
.
The Throttle may require re-calibration .
The throttle, speed limit pot or their associated wiring
7
Speed Pot
may be faulty.
Fault
.
Check
the
throttle
and
speed pot and associated connections
and wiring.
8
Motor Voltage
The motor or its associated wiring is faulty.
Fault
.
Check the motor and associated connections and wiring.
9
Other Error
The controller may have an internal fault.
.
Check all connections & wiring
.
Further issues:
If the above troubleshooting does not help to resolve
the issue please contact the authorised dealer (page 2).
Please have your serial no. to hand to provide to the
authorised dealer, which can be found
11
To Next Page
Loading...
