Instruction Booklet: Troubleshooting
10
Further issues:
If the above troubleshooting does not help to resolve
the issue please contact the authorised dealer (page 2).
Please have your serial no. to hand to provide to the
authorised dealer, which can be found
MeaningDescriptionFlash
1
Battery Low
The batteries are running low.
• Recharge the batteries for a minimum of 12 hours.
2
Low Battery Fault
The batteries have run out of charge.
• Recharge the batteries.
3
High Battery
Fault
Battery voltage is too high. This may occur if
overcharged &/or traveling down a long slope.
• If traveling down a slope, reduce your speed to minimize the
amount of regenerative charging.
• Check the battery and associated connections and wiring.
4
Current Limit
Time-Out
The motor has been exceeding its maximum current
rating for too long. This may be due to a faulty motor.
• Check the motor and associated connections and wiring.
• Turn the controller off, leave for a few minutes and turn back
on again.
5
Park Brake
Fluid
Either a park brake release switch is active or the park
brake is faulty.
• Check the park brake and associated connections and wiring.
• Ensure any associated switches are in their correct positions.
6
Throttle
OONAPU
The Throttle is out of neutral when turning the controller
on.
• Ensure the throttle is in neutral when turning the controller on.
• The Throttle may require re-calibration.
7
Speed Pot
Fault
The throttle, speed limit pot or their associated wiring
may be faulty.
• Check the throttle and speed pot and associated connections
and wiring.
8
Motor Voltage
Fault
The motor or its associated wiring is faulty.
• Check the motor and associated connections and wiring.
9
Other Error
The controller may have an internal fault.
• Check all connections & wiring.
To Next Page
Loading...
