Introduction of the BIOS 3-27
User’s Manual
➤
➤➤
➤
IRQ [3-7, 9-15], NMI:
If any IRQ or NMI (Non-Mask Interrupt) activities occur, this will cause the computer to
re-count the time elapsed.
➤
➤➤
➤
VGA Active Monitor:
If there is any VGA data transfer or any I/O activities, this will cause the computer to
re-count the time elapsed.
➤
➤➤
➤
IRQ8 Break Suspend:
Supports the RTC alarm wake up from suspend function (via IRQ8).
➤
➤➤
➤
IDE Primary Master:
If any IDE primary master I/O activity occurs, it will cause the computer to re-count the
time elapsed.
➤
➤➤
➤
IDE Primary Slave:
If any IDE primary slave I/O activity occurs, it will cause the computer to re-count the
time elapsed.
➤ IDE Secondary Master:
If any IDE secondary master I/O activity occurs, it will cause the computer to re-count
the time elapsed.
➤ IDE Secondary Slave:
If any IDE secondary slave I/O activity occurs, it will cause the computer to re-count the
time elapsed.
➤
➤➤
➤
Floppy Disk:
If any floppy disk I/O activity occurs, it will cause the computer to re-count the time
elapsed.
➤
➤➤
➤
Serial Port:
If any serial port I/O activity occurs, it will cause the computer to re-count the time
elapsed.
➤
➤➤
➤
Parallel Port:
If any Parallel port I/O activity occurs, it will cause the computer to re-count the time
elapsed.
➤
➤➤
➤
Mouse Break Suspend:
Four options are available: Yes
(
No (COM1)
(
No (COM2)
(
No (PS/2)
(Back to
Yes
.
To Next Page
Loading...
