BIOS Setup 3-21
ATA133RAID IDE Controller (For KD7-RAID):
This item selects the onboard ATA133RAID controller. When set to [Enabled], two additional channels
will be provided for adding high performance devices to system.
Serial ATA Controller (For KD7-G and KD7-S):
This item selects the onboard Serial ATA controller. When set to [Enabled], two additional channels will
be provided for adding high performance devices to system.
Broadcom LAN Controller:
This item enables or disables the Broadcom LAN controller.
Onboard LAN Boot ROM:
This item enables or disables the Boot ROM on Broadcom LAN controller.
Back to Integrated Peripherals Setup Menu:
Init Display First:
Two options are available: PCI Slot or AGP. The default setting is PCI Slot. When you install more than
one display card, you can choose either a PCI display card (PCI Slot) or an AGP display card (AGP) to
display the boot-up screen. If you have only installed one display card, the BIOS will detect which slot
(AGP or PCI) you installed it, and everything will be taken care of by the BIOS.
User’s Manual
To Next Page
Loading...
