Setting memory presets
1. Use the UP/DOWN buttons to adjust desk to the desired height.
2. Press the
*
to display the letter S.
3. Press one of the four memory presets (1,2,3, or 4) to save the current height position
to that button’s function.
4. Your desired height has now been set. Perform this set up again to save different
height adjustments.
5. To change a current memory preset, simply perform this setup to override any of the
four numbered buttons.
Reset procedure
This will override any custom upper/lower limits. Ensure that the desk surface and columns
are clear of any items before proceeding.
1. Press and hold DOWN until desk reaches the lowest height position. Release.
2. Press DOWN again but hold until the display flashes RST. Release.
3. Press and hold DOWN once more until the desk lowers and rises slightly.
DO NOT release the DOWN button until after these motions have finished.
4. Desk has been reset.
If a new control box is installed on an existing desk, a RESET must be performed before
using the desk.
Adjust height readout
This handset displays the approximate height of your desk. The accuracy may be affected
by the thickness of the installed top, evenness of the floor, etc. To display accurate height
readout, follow the steps below:
1. Press and hold DOWN until the desk reaches the lowest height position. Release.
2. Measure the distance from the floor to the top of the desk surface.
(NOTE: If height matches the number displayed on the handset, the height readout is
calibrated. If the display is not accurate, proceed to the next step.)
3. Press DOWN again but hold until the display flashes RST. Release.
4. Press and hold
*
until the display flashes with the starting height number.
Display will revert back to RST after 5 seconds if nothing is done.
5. Use the UP/DOWN buttons to adjust the display until the correct height is shown.
(NOTE: Height measurement will adjust 0.1 inches at a time.)
6. After reaching the correct height, wait for 5 seconds. The display will automatically
return to RST which will reset the lowest height measurement.
7. Complete the reset process by pressing and holding DOWN.
(NOTE: Desk will lower and rise slightly. DO NOT release the DOWN button until after
these motions have finished.)
8. Once the new height has calibrated, release the DOWN button and the new height
setting will be shown.
12
To Next Page
Loading...