Set custom upper height limits
1. Use the UP/DOWN to adjust the desk to the desired maximum height.
2. Press
*
and release. Press UP and release.
The display will flash S, indicating it is ready to set the upper limit.
3. Press and hold
*
for 2 seconds.
Display will show 999 and then return to the height readout.
4. The upper limit has been set.
Set custom lower height limits
1. Use UP/DOWN to adjust the desk to the desired maximum height.
2. Press
*
and release. Press DOWN and release.
The display will flash S, indicating it is ready to set the upper limit.
3. Press and hold
*
for 2 seconds.
Display will show 000 and then return to the height readout.
4. The lower limit has been set.
ATTENTION:
When performing reset procedures, legs may retract and extend below any lower height
limits that may be set. Ensure that there is enough clearance under the desk to allows it
to lower all the way.
Restore default upper and lower limits
1. Press
*
and release. The display will show S.
2. Within 5 seconds, press the
*
again and hold for about 2 seconds.
Display will show 555. Height limits will reset to factory default.
Troubleshooting
If the desk is not functioning properly, or the memory presets read RST or any other
error messages (E01 - E13), confirm that all wires are connected and secure. Once all
connections are secure, perform a reset procedure. If the error message is still shown after
performing the reset, contact Able Desk Co.
If height difference between the two legs exceed 1.5 inches, stop the reset procedure and
contact Able Desk Co.
If the handset displays HOT, stop and let the desk cool down for 20 minutes.
13
To Next Page
Loading...