EasyManua.ls Logo

Ableton Move - Declaration of Conformity

Ableton Move
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
5. How does country / state law apply to this warranty?
SOME COUNTRIES / STATES DO NOT ALLOW THE EXCLU-
SION OR LIMITATIONS OF INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES OR PERMIT LIMITATIONS ON HOW LONG
AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS
OR EXCLUSIONS MAY NOT APPLY TO PURCHASERS IN SUCH
JURISDICTIONS.
The following terms apply to purchases of Ableton’s products,
parts and accessories by consumers in Australia. To the extent of
any inconsistency with the terms and conditions in this booklet, the
terms below will apply.
Our goods come with guarantees that cannot be excluded under
the Australian Consumer Law. You are entitled to a replacement or
refund for a major failure and compensation for any other reason-
ably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
The benefits of this Limited Warranty are in addition to other rights
and remedies available to the purchaser under Australian law.
6. Governing Law/Dispute Resolution:
Unless otherwise required by the law of any country or state,
this Limited Warranty will be governed by and construed under
the laws of Germany, Berlin. This Limited Warranty shall not be
governed by the United Nations Convention on Contracts for the
International Sale of Goods, the application of which is expressly
excluded.
This Limited Warranty gives you specific legal rights. You may also
have other rights, which vary from one jurisdiction to another.
For USA and Canadian models only
NOTICE CONCERNING FCC REGULATIONS:
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Ableton Move has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This in-
strument generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. There is
no guarantee that interference will not occur in a particular instal-
lation. If this instrument does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, try to correct the interference by one or
more of the following measures:
A. Reorient or relocate the receiving antenna
B. Move the instrument
C. Increase the separation between the instrument and receiver
D. Connect the instrument into an outlet on a circuit different from
that to which the receiver is connected
E. Be sure that all cables are properly shielded, using a choke or
ferrite where appropriate
F. Consult the dealer or an experienced radio/television tech-
nician for help
THIS INSTRUMENT COMPLIES WITH PART 15 OF THE
FCC RULES. OPERATION IS SUBJECT TO THE FOLLOW-
ING TWO CONDITIONS: (1) THIS INSTRUMENT MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS INSTRU-
MENT MUST ACCEPT ANY INTERFERENCE RECEIVED, IN-
CLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
ESD / EFT warning: This instrument contains a microcom-
puter for signal processing and control functions. In very
rare situations, severe interference, noise from an external source,
or static electricity may cause it to lock up. In this unlikely event,
turn off the instrument, wait at least five seconds, and then turn it
back on again.
This instrument does not exceed the Class B limits for radio noise
emission from a digital apparatus set out in the radio interference
regulations of the Canadian Department of Communications.
Disclaimer
Ableton AG cannot be held responsible for damage or lost or
destroyed data caused by improper use or modification of this
instrument.
Declaration of Conformity
Declaration of Conformity can be found at
www.ableton.com/safety-and-warranty.

Related product manuals