2.5
Operation menu with manual input: Loading the HydroTracer
This chapter describes the steps of the manual operation as shown on the screen.
The pictures clarify the action momentarily needed. Below the picture this action is described
shortly. The panel counting down the number on the right indicates the remaining time in
seconds. The time schedule should be maintained rather accurate. The accuracy might be
reduced by leaving the reactor open too long as well as too short. Press STOP to abort the
test.
Open the reactor by lifting the side
handles simultaneously. The system fan
will stop.
Open reactor by lifting the lid forward into
the direction of the small semispherical
cutout.
To Next Page
Loading...
Need help?
General
