www.abrites.com
11
2021
Abrites Diagnostics for Chrysler, Dodge, Jeep
Programming Keys
Erasing Keys
Below is the procedure, which you must follow in order to program new keys. We give an example for
programming 2 keys:
1. Press the button “Program Keys”.
2. Insert the first valid key into the ignition and turn the ignition On for at least 3 seconds but no longer
than 15 seconds.
Turn the ignition Off and remove the first key.
3. Insert the second valid key and switch the ignition On within 15 seconds. After ten seconds a chime will
sound and the Theft Alarm Light will begin to flash.
Turn the ignition Off and remove the second key.
3. Insert a blank Sentry Key into the ignition and switch the ignition On within 60 seconds. After 10 sec-
onds a single chime will sound. The Theft Alarm Light will stop flashing, and turn On for 3 seconds; then
turn Off.
The new Sentry Key has been programmed. The Remote Keyless Entry (RKE) transmitter will also be
programmed during this procedure.
Repeat this process to program up to a total of 8 keys.
If a programmed key is lost, you need to erase the available keys from the systems memory. This will pre-
vent the lost key from starting the vehicle. All of the remaining keys must then be reprogrammed.
To Next Page
Loading...