48
Radio components, operating units
and detectors
To switch a channel further up, please press
The LED for the next channel will light up or
ash.
You can use channels 4-14 for detectors.
To leave the programming menu, press
repeatedly until the control panel starts to beep.
Close the housing and hold the lid tamper con-
tact (SW4 underneath ESC/DEL) down for about 4
seconds until it beeps twice.
7
8
Please make sure that the detector
channel properties “Permanent” and
“Impulse” are selected correctly.
Please consult the operating manual.
Leave the programming menu
Proceed as follows to learn in detectors. Select
the respective channel and make the detector
transmit a certain radio signal in accordance
with its learn in procedure.
Once the signal is received successfully, the
control panel will beep twice and the LED will
remain lit.
6
Learn in detectors
SELECT
ESC/DEL
To Next Page
Loading...
Need help?
General
