Abus FUMO50010 - Page 23

Technical data
23 | EN
Power supply compliant with EN50131-1:2006+A1:2009 9.2 and
EN50131-6 if installed correctly together with Secvest FUAA50xxx.
Power consump-
tion/energy consumption
TX
RX
3 V battery
50 mA
40 mA
5 V USB
48 mA
38 mA
12 V DC
22 mA
17 mA
13.8 V DC
20 mA
15 mA
Normal voltage
6–15 V DC, 12 V nominal
Battery type
2 AA alkaline batteries
Duracell Procell MN1500, Duracell Industrial ID1500,
Energizer E91
Battery life
The primary power source is the 12 V input. The backup batteries
will provide a reserve of approx. 24 hours in the event of a power
failure.
Battery under voltage
threshold
2.7 V
“Flat battery” fault at <2.7 V
Voltage monitoring
During operation with an external power supply, a fault report is
sent to the alarm control panel as soon as the external power sup-
ply is interrupted. The repeater is then automatically supplied with
power by the batteries. The corresponding notification on the alarm
control panel informs the user of this. The batteries can be moni-
tored as described above.
During battery operation without any external power supply, the
voltage provided by the batteries is also monitored. If the voltage is
below the lower threshold of 2.7 V, a fault report is sent to the
alarm control panel and the user is informed.
Operating frequency
868.6625 MHz narrow band
Power
max. 10 mW
Transmission and re-
ception range
Max. 500 m range outdoors
Standards for intrusion
and panic button de-
vices
The device is compliant with EN 50131-1:2009, EN50131-3:2009,
EN50131-5-3:2005+A1:2008 and EN50131-6 security level 2 if in-
stalled correctly together with the Secvest FUAA50xxx (verified by
ANPI).
EU Directives
RED: 2014/53/EU
EMC: 2014/30/EU
RoHS: 2011/65/EU
WEEE: 2012/19/EU
ErP: 2009/125/EU
Low Voltage: 2014/35/EU
General Safety: 2001/95/EC
General
This product must be installed by a qualified service engineer.