Abus FUMO50010 - Functions and Displays; Operation of the Leds

Functions and displays
32 | EN
Functions and displays
Button C and jumper
Currently without function.
Important
For the repeater functionality, the jumper must not be plugged into both contacts.
Operation of the LEDs
Software version display
The software version of the RF repeater is indicated by the LEDs immediately after the power sup-
ply is connected.
Note
The tamper switch must be open.
 The red left-hand LED indicates the major software version.
 The green right-hand LED then indicates the minor software version
 The yellow LED in the middle then indicates the variant.
Example:
Red left LED flashes once
Green right LED flashes three times
Yellow middle LED flashes twice
Software version “1.3.2”
Signal strength display
Once the alarm panel has been programmed, the LEDs will show the strength of the signal be-
tween the alarm panel and the repeater.
When operational, they signal strength is tested by a message sent from the alarm panel. Switch,
for example, a wireless output on and off to achieve this. The tamper switch must be open.
 Red: poor signal strength
 Red and yellow: medium signal strength
 Red, yellow and green: good signal strength
Note
Set the alarm panel to installer mode in order to test the signal strength while opera-
tional. This ensures that a tamper alarm is not triggered when the repeater is
opened.