Maintenance
34 | EN
Maintenance
Before opening the RF repeater’s cover, make sure that the alarm panel is in in-
staller mode. This prevents the tamper alarm from being triggered.
Test, during routine maintenance, that the RF repeater works properly.
Check the tamper contacts.
Check for signs of insects having made their way in to the device and clean as required.
Replace the batteries every two years or if the alarm panel displays the message ‘Flat battery in
RF repeater’. You can find the battery type to be used as a replacement under Technical data.
Batteries and the device itself must be disposed of in accordance with the
WEEE Directive and applicable local and national regulations.
After removing the old batteries, wait 30 seconds before inserting the new batteries.
Note:
How to replace the batteries:
Put the alarm panel in installer mode.
Open the covers for the lid-fixing screws (see Fig. 1), loosen the screws and open the lid.
Disconnect the 12 V power supply
Take out the batteries.
Wait 30 seconds, then insert the new batteries.
Reconnect the 12 V power supply
Close the cover, tighten the cover fixing screws and close the covers of the screws.
Test the system.
To Next Page
Loading...
