Abus FUMO50020 - Page 61

Seite 2 von 4
FU8200/FUMO50030, FU5200
No
No
FU8220, FU8230/FUSG50010
No
No
FU8300/FUAT50010, FU8310/FUAT50020
Uses 2 channels
Yes
Yes
FU8305
Uses 1 channel
Yes
Yes
FU8320/1/FUMK50000/10, FU5120 / FU5121, FU8430/5
Uses 2 channels (Reed contact+tamper or Alert
+tamper ext. contact)
OP1=Alert, OP2=Tamper or OP3= Alert,
OP4=Tamper. Also can be 2+3
Yes
Yes
FU8330/FUWM50000
OP1=Alert, OP2=Tamper or OP3= Alert,
OP4=Tamper. Also can be 2+3.
Yes
Yes
FU8340/FURM50000
Uses 2 channels. Only the “alert channel” will
respond no tamper exists.
OP is permanent switched, have to be reset through e.
g. manually switching in user menu!!!
Yes
Yes
FU8350/FUBW50000, FU8370/FUGB50000,
FU8380/FUEM50000, FU5110
OP1=Alert, OP2=Tamper or OP3= Alert,
OP4=Tamper. Also can be 2+3
Yes
Yes
FU8390/FUAT50000
Uses 1 channel
Yes
Yes
FU84xx FTSE 96, FU8420 / FU8421 / FU8422
FU8130/FU8140/FUFT50010/20
OP1=Alert, OP2=Tamper or OP3= Alert,
OP4=Tamper. Also can be 2+3
No distinction between cullet lever and the alarm bit
always is sent.
Yes
Yes