Functions and displays
49 | EN
Signal strength displayed by LEDs
When operational, the received signal strength is tested by a message sent from the alarm panel.
To do this, switch "Installer mode -> Test -> Sounders & Signallers -> Indoor sounders" on and off.
The tamper switch must be open.
• Red: poor signal strength
• Red and yellow: medium signal strength
• Red, yellow and green: good signal strength
Set the alarm panel to installer mode in order to test the signal strength while
operational. This ensures that a tamper alarm is not triggered when the sounder is
opened.
You can find notes about testing the signal strength on the alarm panel on the alarm
panel’s installer manual.
To Next Page
Loading...
