AC Infinity CLOUDFORGE T7 - Auto Mode: Low Humidity Trigger; Timer Mode: To Off

24
AUTO MODE (LOW HUMIDITY TRIGGER)
Tapping the auto button sets the low humidity
trigger. Your humidifier will activate if the probe’s
reading falls below this threshold.
Once triggered, your humidifier will ramp up to the
level set in MIST mode. If the probe’s reading rises
above this trigger point, the humidifier will stop
emitting mist.
Leaving the AUTO mode while it is active will pause
it until you return to this mode.
TIMER MODE (TO OFF)
Tapping the timer button sets a countdown time.
Your humidifier will run at the level set in MIST
mode until the countdown ends.
The countdown will begin if no buttons are tapped
for 3 seconds. The time left on the countdown is
displayed as a dial inside of the current mist level.
Leaving the TIMER mode while the countdown is
running will pause it until you return to this mode.
PROGRAMMING