Need help?Do you have a question about the AC Infinity CLOUDFORGE T7 and is the answer not in the manual?
General| Model | CLOUDFORGE T7 |
|---|---|
| Material | Plastic |
| Capacity | 5 liters |
| Noise Level | ≤ 30 dBA |
| Connectivity | Wi-Fi |
| Features | Timer |
Plug the sensor probe into the rear jack and route the head to desired spot areas.
Use UIS extension cord to connect the humidifier to your UIS controller via the rear port.
Plug the humidifier's power cord into a standard electrical outlet to provide power.
Plug sensor probe below display screen and route head. Use probe mount for cable management.
Connect humidifier to UIS controller using the UIS extension cord into the front side port.
Plug the humidifier's power plug into an outlet to power it on.
Details the function of each button (Power, Humidity, Auto, Timer) and display elements (Probe Humidity, Timer, Level, Alerts).
Turns the humidifier ON or OFF. The LCD screen is off when the unit is powered off.
Sets the active misting level, which other modes also use. Avoid setting to zero.
Activates humidifier when probe reading falls below threshold; stops when it rises above.
Sets a countdown timer for the humidifier to turn off. Countdown starts after 3 seconds of inactivity.
To Next Page
