24
ADDING MORE LIGHTS
USING THE SPLITTER
Each controller port can support mix-and-
matched devices regardless of their size.
When using 4-port splitter, plug your first
device into Port 1 for the controller to recognize
as the primary device.
All other devices plugged into the splitter will
follow programming intended for the device
plugged into Port 1.
Splitters are not included.
EXTENDING THE CHAIN
When plugging additional splitters into Port
1, all devices plugged into this chain must be
of the same type (ex. grow lights of any size)
regardless of the length of the chain.
1 2 3 4 1 2 3 4
1 2 3 4
1 2 3 4
To Next Page
Loading...
