Need help?Do you have a question about the AC Infinity THERMOFORGE T3 and is the answer not in the manual?
General| Model | THERMOFORGE T3 |
|---|---|
| Wattage | 1500W |
| Amperage | 12.5A |
| Fan Speed Settings | 3 |
| Heating Method | Ceramic |
| Voltage | 120V |
| Control Type | Digital |
| Timer | 1-12 hours |
| Settings | High, Low, Eco |
| Safety Features | Overheat Protection, Tip-Over Switch |
| Features | Remote Control |
| Temperature Range | 60°F - 95°F |
Covers usage, hazards, user suitability, electrical safety, environmental limits, and proper placement.
Highlights Active Monitoring, Precise Detection, PWM Control, UIS™ Compatibility, and Targeted Heating.
Instructions for standard installation and using the duct extension.
Steps for connecting the sensor probe and powering on the heater.
Details on using the UIS M-M extension cord to connect the heater to a UIS controller.
Explains buttons, controller modes (OFF, ON, AUTO, VPD), and displayed information.
Details OFF Mode and MINIMUM LEVEL settings for the heater's heat function.
Configuration of the AUTO MODE with low temperature trigger points for heater activation.
Configuration of the VPD MODE with low VPD trigger points for heater activation.
Covers alerts for display lock, tilt, overheating, and fan interference.
To Next Page