13
a) Cleaning of optical sensors
It is important to periodically clean the optical sensors to prevent particles of paper
or dust adhering to them.
b) Internal cleaning of the unit
It is necessary to clean the interior of the equipment once a month or more
frequently depending on use. Turn off and unplug the detector before proceeding
with this operation.
Use compressed air to remove dust from inside.
Use a Cleaning Card to remove dust particles adhering to the magnetic heads.
c) Additional recommendations.
The equipment needs to be placed in a clean, dust free environment.
Solution to Operational Problems
cont.
4.2 Maintenance
CAUTION: Before performing any cleaning process, turn off the equipment and unplug it. Please
note that problems or defects caused by lack of maintenance are not covered under the warranty.
To Next Page
