11
Display Console Set Up
It is recommended to plug in the power supply to reduce the battery consumption and extend the
service life.
Note: The sensor array must be powered and updating before powering up the console, or the
console will time-out searching for the sensors. Power up the console last.
Make certain the weather station sensor array is at least 3m away from the console and within 30m of the
console. If the weather station is too close or too far away, it may not receive a proper signal.
Remove the battery door on the back of the display, as shown in Figure 8. Insert three AAA (alkaline or
lithium)) batteries in the back of the display console. The display will beep once, and all of the LCD segments
will light up for a few seconds to verify all segments are operating properly.
Note: The character contrast is best from a slightly elevated viewing angle.
Figure 8
Replace the battery door, fold out the desk stand and place the console in the upright position.
The unit will instantly display indoor temperature, humidity, pressure, tendency, moon phase, and time. The
wind speed, wind gust, wind direction, rain, outdoor temperature and humidity will update on the display within
a few minutes.
Do not press any menu buttons until the data from the outside transmitter is displayed, otherwise the outdoor
sensor search mode will be terminated. When the outdoor transmitter data has been received, the console will
automatically switch to normal mode, from which all further settings can be performed.
While in the search mode, the remote search icon will be constantly displayed.
Note: The power adaptor prongs are not designed to hold the plug in place if it is plugged into a ceiling
outlet.
To Next Page
Loading...
