ACDC Motorized Solutions RollerGlide User Manual

1
ACDC Motorized Solutions Pty. Ltd.
RollerGlide Rolling Door Operator
Owner manual
Congratulations on the purchase of a RollerGlide rolling door operator, this quality
product is designed to provide years of trouble free service
Operation
Two remotes controls are supplied
An optional fixed push button can be used
With each press of the button the door will open, stop or close
The courtesy light switches on for several minutes when the door is operated
Auto-Close
The Auto-Close feature can be selected to close the door automatically after 45
seconds
Safety
Timers are provided to stop the motor if it operates longer than the required time
The power transformer contains a thermal overload device to prevent the transformer
from overheating and causing a fire
The door should only be operated when it can be observed to avoid accidents
Emergency stopping
The RollerGlide will stop and reverse if the door is obstructed or jammed when
closing and will stop if the door is jammed when opening. The obstruction force
setting must be set correctly for the function to operate properly.
Manual operation
The RollerGlide can be set for manual operation by pulling the service lever this
could be required if no power is available and the door has to be opened or closed
Open and Close limits
The RollerGlide is adjustable to stop the door at the correct place in both open and
closed positions
Adding extra remote controls (see figure 3)
Remove the white plastic light diffuser – beware of connected Push button
attached.
• Press the LEARN button on the control panel
• Press one of the buttons on the remote control which you wish to use
• Wait a few seconds and press the same remote button again
• To erase existing remote controls press and hold the LEARN button for 15
seconds
• Up to 25 remote controls may be used
Other products available
Check our Website http://www.acdcms.com.au

ACDC Motorized Solutions RollerGlide Specifications

Electrical

power fuse	1A 240V
power supply	240V AC 50HZ 100W
power transformer output	24V AC
courtesy light	15W/240V
motor torque	High torque 24V DC

Mechanical

overhead height	3.0m (maximum)
width	5.0m (maximum)
maximum lifting capacity	250N
reel diameter	270mm
operating speed	8m/min
weight of main unit	7.5Kg
dimension	200×260×480mm

Summary

Operation

Auto-Close Operation

Feature to automatically close the door after 45 seconds.

Safety Features

Timers stop motor if it operates too long; thermal overload protection.

Emergency Stopping

Door stops/reverses if obstructed; requires correct setting.

Manual Door Operation

Set for manual operation via service lever for power outages.

Limit Setting

Adjustable to stop the door at correct open/closed positions.

Adding Extra Remote Controls

Introduction

Installation Kit Contents

Required Tools

Installation Checks

Mounting Configuration

Fitting Procedure

Manual Limit Switch Setting

Control Panel Limit Setting

Remote Control Operation

Obstruction Force Adjustment

Auto-Close Feature

Manual Push Button

Photoelectric Beam Setup

Electronic Controller Functions

Motor Direction

Adjust motor direction for right or left side installation.

Auto-Close Configuration

Configure Auto-Close feature by moving link on J1.

Remote Control Pairing

Instructions for adding and erasing remote controls.

Open and Close Controls

Details on using open and close controls.

Obstruction Force Controls

Information on setting obstruction force.

Terminal Block (X4) Functions

Details on terminal block connections for detectors and switches.

Electrical Specifications

Mechanical Specifications

Control Features

Service Help

Door Won't Open/Close Fully

Troubleshoot door not opening or closing fully; adjust limit switches.

Remote Control Not Operating

Troubleshoot remote control issues; try second remote, use panel buttons.