ACE COMPUTERS VS-S660I - FAN HANDLING; Location, Fastenings, and Tools; Procedure and Reinstallation; Disposal Information

9/8/2022
ACE146
27
Fans
Location: The chassis fan in the VS-S660I model is located at the
front of the chassis underneath the SATA bays.
Type and number of fastenings: Four (4) rubber mounting pins
Tools required: None
Procedure
Step 1: Ensure the computer is off, unplugged, and any potential
energy is dissipated.
Step 2: Remove the side panel from the chassis as indicated in the
“Chassis Cover” section of this manual.
Step 3: Disconnect the fan wiring from the fan header
on the motherboard.
Step 4: Pull each corner of the fan until it breaks free from
the chassis
Reinstallation
Step 6: Align fan and rubber tabs with 4 screw holes on
chassis and pull each rubber tab through the screw hole
until the fan is secured to the front chassis frame.
Step 7: Plug fan header on motherboard.
Note: Sometimes the rubber mounting pins stick to the
chassis. If that's the case, pull them off the chassis and reinstall them on the fan screw holes. Then proceed
with step 6.
Disposal:
Selective Treatment/Special Handling Per Annex VII, Directive 2012/19/EU: Any plastic
components within the heatsink fan must be removed separately due to the presence of
brominated flame retardants and shall be disposed or recovered in compliance with Directive
2008/98/EC.