41L1700-786-1B 英文
5
CONTROLS AND CONNECTORS
SIGNAL CABLE
Connecting the Signal Cable: the LCD monitor comes with a built-in signal
cable. Plug the signal cable′s 15-pin connector into the computer's VGA port
and tighten the two screws on the cable connector.
Connecting the Power Cord: Plug the AC-power cord into the External
Adapter. Then plug the DC-jack power cable into DC-IN Inlet.
Caution: If the AC outlet is not grounded (with three holes), install the proper
grounding adapter (not supplied).
Figure 2 Connecting Cables
1. Signal Cable 3. AC Power Cord
2. DC-Jack Power Cable 4. External Adapter
To Next Page
Loading...
