Jumper and Connector Locations 5-5
Figure 5-3. RTC Battery
4. Locate the RTCRST# jumper.
5. Use an electric conductivity tool to short the two points of the RTCRST# jumper.
6. Plug in AC, keeping the RTCRST# jumper shorted.
7. Press Power Button until BIOS POST is finished, then remove the conductivity tool from
the RTCRST# jumper.
8. Restart the system. Press F2 to enter BIOS Setup menu.
9. If there is no Password request, BIOS Password is cleared.
10. If a password is requested, repeat Steps 1 through 9.
Clear CMOS Jumper 0
Figure 5-4. CMOS Jumper
Table 5-3. CMOS Jumper
Item Description
RTCRST# Clear CMOS Jumper
To Next Page
Loading...
