Acer Aspire 3935 - Removing the Touchpad Board; Removing the Cover Switch Cable

Acer Aspire 3935 Service Guide 49
Removing the Touchpad Board
1. Perform the “Removing the Fingerprint Reader Board” procedure on page 47.
2. Carefully pry loose the touchpad board from the upper case to detach it.
CAUTION: The touchpad board is glued to the upper case. Remove the touchpad board only if it is defective.
IMPORTANT: A circuit board that is >10 cm
2
has been highlighted with a red rectangle as shown in the above
image. Follow the local regulations for disposing this type of circuit board.
Removing the Cover Switch Cable
1. Perform the “Removing the Upper Case” procedure on page 43.
2. Release the cover switch cable from its upper case latches to remove it.