48 Chapter 3
6. See “Removing the DIMM Module” on page 42.
7. See “Removing the Keyboard” on page 44.
8. See “Separating the Upper Case from the Lower Case” on page 45.
9. Release the latch and disconnect the touchpad cable from the connector.
10. Pry to loosen and detach the touchpad board.
WARNING: The touchpad board is glued to the upper case, only remove the touchpad board if it is defective.
Note: Circuit boards > 10cm
2
has been highlighted with the yellow square as shown in the figure
above. Please detach the circuit boards and follow the local regulations for disposal.
To Next Page
Loading...
