5
1 1*4 S/PDIF out header (for ALC888S sku)
1 3 pin CPU Fan connector
1 3 pin System FAN connector with linear circuit
1 24pin + 4pin ATX interface PS3/PS2 SPS connector
1 2*7 pin front panel IO header
1 Jumper for clear CMOS
1 on board buzzer
2 reserved 2pin GPIO connector
Color management for on board connecter (pls provide proposal)
Power Supply
Power Supply Mounting Features
Chassis accepts ATX-style power supply
Chasses accepts PS2, PS3 style power supply
Features for internal mounting tab
Location of 4 external mounting holes
Power Supply Electrical Design Feature
500W/300w/250w in stable mode (Acer Assign System Power Unit)
Voltage design should be covered +5V, +3.3V, +12V, +5VSB, -12V (attention to
12V output capability)
Demand for both PFC/Non-PFC solutions (two different quotations are
needed)
Minimum 4 Serial ATA power connector solution should be included (by
default)
Minimum 1 big 4-pin graphic card connector included
Minimum small 4-pin power connector included
Full Range PSU
PS2 style
To Next Page
Loading...
