What to do if my Acer Aspire M3970 Desktop system will not power on?
If your Acer Desktop system isn't powering on, first ensure the power cable is securely connected both to the system and the AC power source. Also, verify that the voltage selector switch is set to the correct voltage.
What does it mean when my Acer Desktop beeps for memory not installed or memory error?
A continuous long beep indicates that the memory is either not installed correctly or there is a memory error in your Acer Desktop.
What does it mean when my Acer Desktop beeps for VGA not installed or VGA error?
One long beep followed by two short beeps that repeat indicates that the VGA is either not installed correctly or there is a VGA error in your Acer Desktop.
What does two short beeps mean on Acer Aspire M3970?
Two short beeps indicate that the CMOS is damaged in your Acer Desktop.
Detailed technical specifications for processor, BIOS, and mainboard.
Guide to configuring system settings through the BIOS setup utility.
Procedure for safely removing the CPU from its socket.
Instructions for disconnecting and removing the hard disk drive.
Steps to disconnect and remove the computer's power supply unit.
Step-by-step guide for installing a new CPU into the socket.
Steps for performing hardware diagnostics on the system.
Table of beep codes indicating BIOS error conditions.
Instructions on how to recover the system's BIOS if corrupted.
To Next Page
General