Acer Aspire M5811 - 2-4:Create a“RAID Ready” System into RAID 10 with three Hard Drives by‘Create RAID Volume from Existing HDD Drive ’

91 Chapter 7
Step 8:At least select two HDD as Menber Hard Drive(s).
Picture13
Step 9:Specify Volume Size then press "next".
Step 10:Press "next" to finish setup and start create RAID5.
Step 11:It may takes half and hours to create RAID5.After create completely,it will ask to reboot to finish create
RAID5.
2-4:Create a“RAID Ready” System into" RAID 10" with three Hard Drives by‘Create RAID Volume from
Existing HDD Drive ’.
Step 1:Install Win7 OS with one SATA HDD.
Step 2:Shut down the system,then add other two serial ATA hard drives in the system.
Step 3:Boot to OS desktop, open the Intel® Matrix Storage Console.
Step 4:Click on the by‘Create RAID Volume from Existing HDD Drive ’ to create a RAID volume.
Step 5:Click "Next" at create a RAID volume window.
Step 6:Key the name in "Volume Name" and select "RAID 10" in RAID Level.
Picture14