20 Chapter 2
The
Set Supervisor Password
or
Set User Password
box opens.
2. Type the current password, then press
Enter
.
3. Press
Enter
twice without entering anything in the new and confirm password fields.
4. You will be prompted to confirm the password removal.
5. Press
Enter
.
6. Press
F10
to save the password and close the Setup Utility or you can proceed to setting a user
password.
Resetting a password
If you have forgotten the user password, the computer will continue to function normally but you will have
limited access to the Setup utility.
If you have enabled the Password on Boot field and you forget the supervisor password, you will not be able to
boot up the computer. The same thing applies if you forget the HDD password.
To clear a lost BIOS password (user or supervisor password) you need to short the clear password hardware
gap located on the system board. Go to page 21 for instructions.
To regain access to your computer if you lose the HDD password, you need to generate a master password
and unlock your hard drive. Go to page 22 for instructions.
Boot
Use the Boot menu to set the preferred drive sequence in which the Setup utility attempts to boot the operating
system.
To set boot drive sequence:
1. Press
↑
or
↓
to highlight a bootable device.
2. Press
F5
or
F6
to move the selected device up or down the boot sequence.
3. Press
F10
to save the changes you made and close the Setup utility.
Maintenance and Service Guide,Service Manual,Motherboard Schematics for Laptop/notebook http://faqp.ru/
HTTP://FAQP.RU/ - Схемы, сервис мануалы, инструкции по разборке ноутбука
To Next Page
Loading...
