Appendix A Server management tools
104
8 Press <Enter> to end the array configuration.
9 Select YES to save the configuration and press any key to return to
the Configuration menu.
10 Press <Esc> to return to the Management Menu.
Initialing a RAID volume
1 Select Initialize from the Management menu. All logical drives
should be listed under Logical Drives.
2 Press the space bar to select drives for initialization. The selected
drive will be shown in yellow.
3 After selecting the drives, press <F10> and select YES to start the
initialization process.
4 When initialization is complete, press <Esc> to continue.
5 Press <Esc> to return to the Management Menu.
Assigning a hot spare disk
1 Select Objects from the Management menu.
2 Select Physical Drive from Objects. All of the HDDs will be listed.
3 Select a drive marked as READY and press <Enter>.
4 Select Make Hot Spare and press <Enter>.
5 Select Yes and the selected drive changes from READY to HOTSP.
6 Press <Esc> to return to the Management Menu.
Saving and Exiting the RAID Configuration Utility
1 After performing RAID configuration, initialization and assigning
the hot spare disk, press <Esc> in the Management Menu and
select YES to exit the RAID Configuration Utility.
2 Press <Ctrl> + <Alt> + <Del> to reboot the server.
3 Now you can start to install the operating system.
To Next Page
Loading...
