What to do if hard disk drive test failed on Acer Server?
If the hard disk drive test fails on your Acer Server, try these steps: First, enter BIOS Setup and load default settings. If the issue persists, check the hard disk drive cable. If that doesn't resolve the problem, the hard disk drive itself may be faulty or there may be a problem with the main board.
Why is incorrect memory size shown on Acer Server?
If your Acer Server shows an incorrect memory size or repeats it during POST, try the following: First, ensure the memory modules are properly inserted into the DIMM sockets, and then reboot the system. If the issue persists, the memory module itself may be faulty, or there could be a problem with the main board.
What to do if processor fan does not run on Acer Server?
If the processor fan on your Acer Server isn't running but the power supply fan is, consider these possibilities: First, ensure the system is not in power saving mode. If it is not, with the system power on, measure the voltage of the processor fan connector; it should read +12Vdc. If the voltage is normal but the fan still doesn't work, replace the fan. If the problem persists, there may be an issue with the main board.
Why Acer Server fails to enter power saving mode?
If your Acer Server works but doesn't enter power saving mode when Power Management Mode is enabled, try these steps: First, enter BIOS Setup and load the default settings. If that doesn't work, reload the software from the Recovery CD.
General| Form Factor | Tower |
|---|---|
| Storage | 4 x 3.5" hot-swappable bays |
| RAID Support | RAID 0, 1, 5, 10 |
| Network | 2 x Gigabit Ethernet ports |
| Operating System Support | Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server |
Step-by-step guides for installing/removing chassis, CPU, fans, memory, cards, and drives.
Steps for configuring Intel onboard SATA RAID.
Steps for configuring LSI onboard SATA RAID.
Steps for configuring MegaRAID SAS controllers.
Catalog of error symptoms, beep codes, and POST messages.
Guides for BMC/iKVM events, and undetermined problems.
Detailed specifications for hardware, environment, mechanics, and power.
Steps for memory installation and suggested population table.
Instructions for entering BIOS setup and navigating primary menus.
Configuration options for processor, memory, and chipset.
Configuration options for ACPI, SATA/SAS, and PCI devices.
Configuration options for USB, legacy devices, power, and console redirection.
Details on Hyper-Threading, Virtualization, AES-NI, and Turbo Boost.
Settings for P-States, C-States, Prefetching, and CPU speed.
Information on total memory, DIMM status, and retesting.
Configuration for Intel VT-d, TXT, and ME Subsystem.
Configuration for High Precision Event Timer and WHEA Support.
Configuration for SATA controller and mode (IDE, RAID, AHCI).
Configuration for PERR#/SERR#, PCI Express ROMs, and graphics/LAN.
Settings for detected USB devices and legacy support.
Configuration for Deep Power Off, RTC Alarm, AC Power Loss, and ASPM.
Configuration for console redirection, terminal type, and baud rate.
Settings for administrator/user passwords, and button lockout.
Settings for BIOS write protection and TPM support.
Procedures for managing system passwords.
Setting boot device priority and configuring boot options.
Steps for configuring 3041E-R RAID controller.
To Next Page
