39
8 Insert the new 5.25" storage device (1) and slide the tool-less
bracket to the right in the locked position (2).
9 Connect the power (3) and SATA cables (4) to the new 5.25" drive.
10 Replace the front bezel.
11 Observe the post-installation instructions described on page 29.
To upgrade or replace a defective storage device:
1 Perform the pre-installation instructions described on page 28.
2 Remove the side panel described on page 36.
3 Remove the front bezel. Perform steps 4 and 5 of the previous
section.
To Next Page
Loading...
