123
5 Press and hold the <Ctrl> key and select the drives that you want
to add into the array. After selecting the drives, click on Add to
Array.
6 Click on Accept DG then Next.
7 Select the array you just created, click on Add to SPAN and Next.
8 Select the RAID Level you want to use, create the logical volume by
specify the size at Select Size and click on Accept to create the
logical volume.
9 Click on Next after you creating the logical volume.
10 Click on Accept and Yes to save the configuration.
Initialing a RAID Volume
1 After creating the logical volumes on all RAID volumes, click on
Accept and Yes to save the configuration.
2 Click on Yes to initialize the new logical drives. You will see all the
logical drives listed.
3 Click on Home to go back to the configuration menu.
Assigning a Hot Spare Drive
1 Select a free disk marked as UNCONF GOOD and listed under
Physical Drives.
2 Select Make Global Dedicated HSP or Make Dedicated HSP and
click on Go.
3 Click on Home to go back to the configuration menu. You will see
the disk marked as Hotspare in pink and listed under Physical
Drives.
4 Now you can reboot the system and install the Operating System.
Select Exit, click on Yes and press <Ctrl> + <Alt> + <Del> to reboot
the system.
To Next Page
Loading...
