3 System upgrades
44
Removing a 5.25-inch storage device
1 Perform the pre-installation instructions described on page 26.
2 Remove the side panel described on page 28.
3 Disconnect the SATA (2) and power (1) cables connected to the
storage device. Pull out the tab (3) and pull out the device from
the drive bay (4).
4 If you intend to install a new storage device, refer to the previous
section.
5 Re-install the side panel and close the bezel door.
6 Observe the post-installation instructions described on page 27.
To Next Page
Loading...
