System
Mode - Standard
HDMI
Picture
Color
Input
Audio
OSD
On
Quick Start Mode
Wide Mode
System
Hot Key Assignment
DDC/CI
X
Enter
Move
Normal
Auto Source
Quick Start Mode
Off
Performance
HDMI Black Level
On
Full
DP Format DP 1.2
1.
2. Toggle the joystick to the up or down to select System from the OSD.Then toggle to the
right to
navigate to the element you wish to adjust and press the joystick to enter it.
3. Toggle to the left or right to control functions.
4. Input: Select the source from HDMI2.0, DP.
Auto Source: The default is “On”, which can support auto search for signal source in
order.
Note: Surround application must set Auto Source is “Off”.
6. DP Format: Default is DP1.2, can selection support DP1.1,1 or DP1.2 format.
Wide mode: You can select which screen aspect you are using. The options are Aspect
and Full.
8.
9. DDC/CI: Allows the monitor settings to be set through the software on the PC.
-----------------------------------------------------------------------------------------------------------
Note: DDC/CI, short for Display Data Channel/Command Interface, which allows
monitor controls to be sent via software.
10. HDMI Black level: Select to set HDMI2.0 black level.
11. Quick start mode: Select Off or On. Turn on to speed up boot speed.
To Next Page
Loading...
