Disassembly Procedures 1-17
Mainboard Removal 0
Prerequisite:
LCD Module Removal
1. Locate the mainboard (E) on the top assembly. Refer to Figure 1-22.
2. Peel off and remove the adhesive tape (A) covering the keyboard connector
(Figure 1-22).
Figure 1-22. Mainboard Removal
3.
[For models with a Second Microphone Board:]
Disconnect the second microphone
board cable from the mainboard connector (B) (Figure 1-23).
4.
[For models with a Second Camera Module:]
Disconnect the second camera module
cable from the mainboard connector (C) (Figure 1-23).
5. Disconnect the 30-pin USB board FPC from the mainboard connector (D)
(Figure 1-23).
6. Disconnect the 40-pin USB board FPC from the mainboard connector (F) (Figure 1-23).
7. Disconnect the USB board cable from the mainboard connector (G) (Figure 1-23).
8. Disconnect the touchpad FFC from the mainboard connector (J) (Figure 1-23).
9. Disconnect the keyboard FPC from the mainboard connector (K) (Figure 1-23).
10. Disconnect the speaker cable from the mainboard connector (L) (Figure 1-23).
11. Remove two (2) screws (H) securing the mainboard in place (Figure 1-23).
To Next Page
Loading...
