Acer Chromebook Spin R752T - LCD Module Removal

Disassembly Procedures 1-13
LCD Module Removal 0
Prerequisite:
Battery Pack Removal
1. Disconnect the WLAN antennas cables from the WLAN module connectors (A)
(Figure 1-16).
2. Disconnect the G-sensor cable from the mainboard connector (B) (Figure 1-16).
3.
[For models with a Digitizer board:] Disconnect the Digitizer cable from the
mainboard connector (C) (Figure 1-16).
4. Disconnect the eDP cable from the mainboard connector (D) (Figure 1-16).
5. Unroute all cables from the cable guides (Figure 1-16).
Figure 1-16. LCD Module Removal
6. Place the system on a flat surface and open the LCD module (G) as shown in
Figure 1-17.
7. Remove four (4) screws securing the LCD module in place (Figure 1-17).
Figure 1-17. LCD Module Removal
B
C
A
D
G