Acer EB5 Series User Manual

9
Installation
To install the monitor on your host system, please follow the steps below:
Steps
1. Connect the video cable
a. Make sure both the monitor and computer are switched o.
b. Connect the HDMI Cable (Only HDMI-Input Model)
(1) Make sure both the monitor and computer are switched o.
(2) Connect one end of the 19-pin HDMI cable to the back of the monitor and the other end to
the computer's port.
c. Connect the DP cable (only for DP models).
(1) Make sure both the monitor and computer are switched o.
(2) Connect one end of the 20-pin DP cable to the back of the monitor and the other end to the
computer's port.
2. Connect the power cord
Connect the power cord to the monitor, then to a properly grounded AC outlet.
3. Turn on the monitor and computer
Turn on the monitor rst, then the computer. This sequence is very important.
4. If the monitor does not function properly, please refer to the troubleshooting section to diagnose
the problem.

Acer EB5 Series Specifications

General

Brand	Acer
Model	EB5 Series
Category	Monitor
Language	English