Acer G195W - DVI;HDMI Connector Pin Assignment

Acer Acer –LCD-G195W
10
Temperature : 25 ± 5°C
Warm-up time : 30 minutes minimum
Checking display modes : All the specified modes
5.1 Panel general specifications
5.1.1 General specifications
Supplier
INL
Model name
MT190AW02 V.0
Display Area 408.24 ( H ) x255.15 ( V ) , 19W” diagonal
Pixel Pitch 0.3(H) x 0.3(V)
Display Colors: 16.7 Million (RGB 6-bit + HiFRC)
Number of Pixel 1440x900 pixels
Pixel Arrangement RGB vertical stripe
Brightness 300cd/m
2
(Typ.) 250cd/m
2
(Min.)
Contrast Ratio 1000:1 Typical
Viewing Angle H.160, V.160 typ. (CR>=10)
Display Mode Normally White
Frame rate 60Hz
Response Time Tr + Tf = 5ms Typical
Surface Treatment
Anti-glare, Haze = 25%,
Hard coating (3H)
Lamp 4 CCFL
Outline Dimension 428(W)x278(H)x16.5(D) Typ
Remark: If phase in other second panel, Panel general specifications pls refer to the panel spec
Note : Detial Spec PLS follow panel Spec
5.1.2 LCD module defects
LCD module defects check follows IIS.
6. Function Specifications
6.1 Keypad Function
6.1.1 Control buttons
[AUTO]
A. When OSD un-displays, press [AUTO] and the function menu will show on the screen;
B. When function menu displays, press [AUTO] to perform auto-adjustment;
C. When OSD displays, press [AUTO] to return to previous level menu;
D. When “e Color OSD” OSD displays, press [AUTO] to exit the OSD.
[MENU]
A. When OSD isn’t shown on screen, press [MENU] to enter the function menu;
B. When function menu displays, press[MENU]to enter the main menu OSD;
C. When OSD displays, press [MENU] to perform function of menu icon that is highlight or
enter next level menu
[◄]
A. When OSD isn’t show on screen, press [◄] to enter the function menu;
B. When “MENU OSD” displays, press these keys to change the contents of an
adjustment item, or change an adjustment value;
C. When Function menu displays, press [◄] to show “Audio” OSD and decrease the
volume.
[►]
A. When OSD isn’t show on screen, press [►]to enter the function menu;
B. When “MENU OSD” displays, press these keys to change the contents of an
adjustment item, or change an adjustment value;
C. When Function menu displays:
a. Press [►] key one time to search (a port with signal in order)