Service and Maintenance 5-49
4. Perform steps 4 and 5 of the Function Board Installation on page 3-33.
5. Attach a rubber pad as marked below.
Figure 3:79. Installing a Rubber Pad
6. Connect the GPS antenna connector to the mainboard connector. Then, route the GPS
antenna cable to pass underneath the battery cable and through the guides around the battery.
Figure 3:80. Connecting the GPS Antenna
7. Install the left speaker (see Speaker (Left) Installation on page 3-38).
8. Install the camera module (see Camera Module Installation on page 3-28).
To Next Page
Loading...
