Service and Maintenance 5-17
Lower Case Installation
Before installing the lower case, make sure the following are installed:
• Rear microphone (if not, perform Microphone (Rear) Installation on page 3-72).
• Docking board (if not, perform Docking Board Installation on page 3-75).
1. Align the bottom side of the lower case to the bezel and connect the docking board cable
connector to the mainboard connector.
Figure 3:22. Connecting the Docking Cable
2. Attach the protective tape to secure the docking board cable connector.
Figure 3:23. Securing the Protective Tape
To Next Page
Loading...
