INSTALLATION
Projection
• Front: The factory default setting.
• Front Ceiling: Turns the image upside down for ceiling-
mounted projection.
• Rear: Reverses the image so you can project from behind
a translucent screen.
• Rear Ceiling: Reverses the image so you can project from
behind a translucent screen for ceiling-mounted
projection.
Test Pattern
Displays a grid pattern for you to adjust the image size and
focus and check that the projected image is free from
distortion.
Light Source
Settings
• Light Source Mode: Use this function to choose your
desired light source mode.
• Reset Light Timer: Resets the light source timer.
• Light Source Information: Shows the number of hours
the lamp has been used.
12V Trigger
If activated, the projector will send electronic signal out
when it is turned on.
High Altitude
Mode
Choose "On" to turn on the High Altitude mode. When this
function is turned on, the projector fans operate at full speed
continuously to cool down the projector’s temperature.
To Next Page
Loading...
