Acer XB253Q

ACER XB253Q
7
4. Disassembly and Assembly SOP
XB253Q
4.1 Disassembly Procedures
Preparation before disassemble
1.Clean the room for disassemble
2.Identify the area for monitor
3.Check the position that the monitors be placed and the quantity of the monitor ;prepare the area for material flow;
according to the actual condition plan the disassemble layout
4.Prepare the implement, equipment, materials as bellow:
1) working table
2) Screw-driver: Philips-head screwdriver, Hex-head screwdriver
3) knife
4) glove
5) cleaning cloth
6) ESD protection
After unplugging the power cord, the power board still have power energe. Please pay attention
when disassembling/assembling.
S1
Disassemble the RC,
stand and base
Before Disassembling & Assembling, monitor need to be put on the sponge and
the Insulation glove must be wore during the process.
Disassemble base and stand from the RC(Rear Case) as picture 1.
Unlock RC center screw as picture 1.
Disassemble RC from monitor and extract the FFC CTRL from the IF BD as picture 2
PICTURE 1 PICTURE 2
S2
Disassemble CTRL BD
Tear off the adhesive tape of the FFC CTRL from the RC as picture 1.
Disassemble the CTRL BD from the RC as picture 2.
Disassemble the FFC CTRL from the CTRL BD.
PICTURE 1 PICTURE 2
CTRL BD
CTRL BD