Acer XZ271U - Page 2

LCD Monitor Quick Setup Guide
FreeSync Premium(HDMI/DP Only)
It can allow a FreeSync Premium supported graphics source to dynamically adjust display refresh rate based on typical content frame
rates for power efficient, virtually stutter free and low-latency display update.
Regulations and safety notices
FCCnotice
This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful
interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
CEdeclarationofConformity
Hereby, Acer Inc., declares that this LCD monitor is in compliance with the essential requirements and other relevant provisions of
EMC Directive 2014/30/EU, Low Voltage Directive 2014/35/EU, and RoHS Directive 2011/65/EU and Directive 2009/125/EC with
regard to establishing a framework for the setting of ecodesign requirements for energy-related product.
Notice:Shieldedcables
All connections to other computing devices must be made using shielded cables to maintain compliance with EMC regulations.
Notice:Peripheraldevices
Only peripherals (input/output devices, terminals, printers, etc.) certified to comply with the Class B limits may be attached to this
equipment. Operation with non-certified peripherals is likely to result in interference to radio and TV reception.
Caution
Changes or modifications not expressly approved by the manufacturer could void the user authority, which is granted by the Federal
Communications Commission, to operate this product.
Operationconditions
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Notice:Canadianusers
CAN ICES-003(B) / NMB-003(B)
DisposalofWasteEquipmentbyUsersinPrivateHouseholdintheEuropeanUnion
This symbol on the product or on its packaging indicates that this product must not be disposed of with your other
household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a
designated collection point for the recycling of waste electrical and electronic equipment. The separate collection
and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that
it is recycled in a manner that protects human health and the environment. For more information about where you
can drop off your waste equipment for recycling, please contact your local city office, your household waste disposal
service or the shop where you purchased the product.
In order to prevent damage to the monitor, do not lift the monitor by its base.
Acer monitor is purposed for video and visual display of information obtained from electronic devices.
DANGER
Toavoidshockhazard:
• Do not remove the covers.
• Do not operate this product unless the stand is attached.
• Do not connect or disconnect this product during an electrical storm.
• The power cord plug must be connected to a properly wired and grounded power outlet.
• Any equipment to which this product will be attached must also be connected to properly wired and grounded
power outlets.
• To isolate the monitor from the electrical supply, you must remove the plug from the power outlet. The power
outlet should be easily accessible.